Digitax Printer
- High printing speed: 30 – 35 mm/sec
- Load Logos into printer memory (average logo size 3 Kb each).
- Easy paper change (Autoload)
The PRINTER TRE has a wide range of uses in addition to the standard printing ones:
- High printing speed: 30 – 35 mm/sec
- Power Supply: 9 – 16V
- Easy paper change (Autoload)
- Paper and sensor
- ESC/POSTM emulation
- Standard international characters font
- Standard line printing with autofeed
- Two dimension font scaling
- Print Density
- Online device checking
- Graphic image mode for bitmap printings
- Load Logos into printer memory (average logo size 3 Kb each)
- Available memory for logo’s storage (30 Kb)
- Print selected logo command
- RS232 or TTL serial interface (2400 - 19200 bps)
| GENERAL FEATURES | |
| Resolution | 200 dpi (8dots/mm) |
| Maximum Print Speed | 450 Dot Lines per second |
| Horizontal Dot Pitch | 0.125 mm |
| Vertical Dot Pitch | 0.125 mm |
| Printing Method | Direct Termal, Line Dot Printing |
| Total Number of Dots / Line | 384 |
| Paper | Standard Termal Paper 57 mm x 30 mm diameter |
| printable area | 48 mm |
| Interface | RS232 9600 Baud N81 or TTL |
| Credit Cart Driver identification |
Magnetic card reader embedded tracks I - II - III (Full version) |
| APPLICATION NOTES | |
| Temperature range (operation) | 0° C to + 50° C |
| Temperature range (storage) | -25° C to + 70° C |
| Humidity range (operation) | 10% to 95% without condensation |
| Humidity range (storage) | Up to 95% without condensation |
| note 1 | To prevent stepper motor termal overheat, it is required to respect a maximum on/off printing ratio (duty cycle) of 80-90% |
| note 2 | The printer may not print if power supply voltage is out of operating range 9 – 16V. |